Product Catalogue
- Transfer Type Molding Machine
- Plate Vulcanizing Press
- Vacuum Vulcanizing Press
- Rubber Injection Molding Machine
- Transfer Type Molding Machine For Thermoset Plastic
- Rubber Mould
- Rubber Products
Proportional solenoid
Attention:
1. For installation, use screws with a tensile strength of greater than 85kg/mm2 (Available upon purchase).
2. Inlet O-Ring must fully comply with GB1325-76 Standards.
3. Notes For Plug Use
a) Remove the hollow crew from inside the cover, tighten it again after wire is connected to the base.
b) A rubber ring is provided at cable entrance, the plug wiring will be tightly clamped when the threaded cover is tightened.
(Note: 3-wire cable should be used for connection)
Model description
External dimensions
1. For installation, use screws with a tensile strength of greater than 85kg/mm2 (Available upon purchase).
2. Inlet O-Ring must fully comply with GB1325-76 Standards.
3. Notes For Plug Use
a) Remove the hollow crew from inside the cover, tighten it again after wire is connected to the base.
b) A rubber ring is provided at cable entrance, the plug wiring will be tightly clamped when the threaded cover is tightened.
(Note: 3-wire cable should be used for connection)
Technical specification
Model |
BMF45P1-50/1.4 |
BMF45P1-90/1.4 |
Rated Current (mA) |
0.7 |
0.7 |
Rated Attraction Force (N) |
50 |
90 |
Rated Travel (mm) |
1.4 |
1.4 |
Force Hysteresis (%) |
2 |
2 |
Current Hysteresis (%) |
2 |
2 |
Nominal Fluid Pressure (MPa) |
10 |
10 |
Model description
External dimensions